I have been building one of these. The magnatraction brushes seemed to be to tall so I found a set of old ones that were almost wore out and still had to sand them down a bit. It runs quite good now.
what should i use/t-jet super II brush tubes?
:wave: hey tuners I just got this chassis from jag hobbies but i forgot to ask what do u use for brushes. tjet brushes do fit but there is no upward force against the arm.i've used contact shoe springs in lou of brushes before(they work good)i did try mag spring/brush combo,but just seemed to tall.so any idea what to use?i spect this is some type of super II set-up but i don't know never saw 1 close up. if you have set 1 of these-up i'd like to hear all about it!!!
1 - 1 of 10 Posts
1 - 1 of 10 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Hobbyist Forums
A forum community dedicated to all Hobbyists. Come join the discussion about die cast, models, slot cars, radio control vehicles, classifieds, swaps, and more!
Full Forum Listing
Recommended Communities
