Hobbyist Forums banner
1 - 5 of 5 Posts

· Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
I purchased a Walbro carb rebuild kit # K22-HDA .
i intend to rebuild the carb on a Husky chainsaw for my pastor.
I'm pretty good at rebuilding Mikuni carbs on 2 stroke dirt bikes. BUT, I'd appreciate any tips before I tear into this Walbro!
Thanks in advance!

Tony P
Unionville, NC
 

· Registered
Joined
·
27 Posts
Discussion Starter · #4 ·
The chainsaw actually runs pretty well. Fresh fue lis always used.
Problem is, the saw takes about 5 pulls to start, then runs fine. If you shut it down, and try to restart while hot, it is really hard to start. The owner, my pastor, paid good money to a local repair shop. They replaced the coil, sparkplug, and the fuel filter. with no improvement.
He asked me to rebuild the carb.

Thanks for all help!
Tony P
 

· Registered
Joined
·
27 Posts
Discussion Starter · #8 ·
Hey guys, can I purchase a new or rebuilt Walbro carb for this Husky 254 chainsaw? I just cannot get it to run right.
A local shop tried to "fix" it too, but it still is not right.


tonyp884 said:
I purchased a Walbro carb rebuild kit # K22-HDA .
i intend to rebuild the carb on a Husky chainsaw for my pastor.
I'm pretty good at rebuilding Mikuni carbs on 2 stroke dirt bikes. BUT, I'd appreciate any tips before I tear into this Walbro!
Thanks in advance!

Tony P
Unionville, NC
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top