Hobbyist Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
136 Posts
Discussion Starter #1
i`ve made my own vacforming box and i intend to use my cylinder vacuum for the forming process, i just wanted to know if anybody here has any `homemade` vacforming experience, i have a fan assisted oven, but i dont know what temperature i should have it on to soften the .50mm styrene i will be using, i would be greatful if anyone can help, thanks.
 

·
Registered
Joined
·
404 Posts
I use .081 styrene. I set the oven at 450 F for about 3 minutes. I like to get 4-5 inches of sag before "slamming." Also, ensure your frame is larger than your table (so the styrene covers the entire table surface.

Shoot me an email if you have any specific questions ([email protected]).

Scottie
 
1 - 3 of 3 Posts
Top