Hobbyist Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
1,078 Posts
Discussion Starter #1
Not sure if 3D printing a figure is considered "modeling", but thought I'd share this here.

Can't remember where I picked up the STL file, it was months ago and I just got around to printing a couple of them and last night I painted one.

The trigger on my airbrush was acting up so didn't have the fine control I normally do, but it came out OK. Now that I've taken the airbrush apart, cleaned and lubed it, I may go back over some areas.



 

·
Registered
Joined
·
399 Posts
Looks like a good print and the paint is awesome.

Not sure if 3D printing a figure is considered "modeling",
What are you talking about? i've been posting heaps of 3D printing.
 

·
Registered
Joined
·
1,078 Posts
Discussion Starter #5
What are you talking about? i've been posting heaps of 3D printing.
I know, a model is a model, but in science fiction it just doesn't seem right to call an activity modeling if there is no glue involved. 😜

Or silicone, in the case of other types of modeling... 😁

This place has a million smileys but doesn't have the rimshot one to put at the end of a joke... 😢
 
1 - 7 of 7 Posts
Top