Hobbyist Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
764 Posts
Discussion Starter #1
I bought a stock motor lethe and the slave motor is an old traxxas 19 turn motor, and I was concerned that this motor is too strong and could damage coms or bit. Any suggestions??????????????????????????
 

·
R/C Nut
Joined
·
653 Posts
The 19 turn motor will work ok if you run it on 3 cells instead of 4 or around 3-3.5 volts from a charger
 
1 - 5 of 5 Posts
Top