Hobbyist Forums banner
  • If you've ever been interested in the history of Zee Toys or Maisto over the course of the 80s, 90s and into the modern day, you should come over to the Hobbytalk Ask Me Anything with Chepp going live on Tuesday, September 21st and running until Thursday, September 23rd. Don't miss out! You can ask your questions here!
1 - 2 of 2 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter · #1 ·
I'm having a memory loss. I got the trimmer started. From my previous post about fuel line connections, they were reversed, it started and ran really bad. The previous owner also tried to adjust the carb to get it to run so they are all messed up. It has the high and low side adjustment screws. It would start and run but that was it, would die when given gas. So now I messed it up and it won't start
I forgot where to set the screws to get it started before adjusting the high and low.
Can anyone guide me or have steps somewhere on how to do it?
thanks
 

·
Registered
Joined
·
1,510 Posts
It's hard to say, as many newer carbs. have a prelim setting of 3 or even 4 turns out.
If this is an older Ryobi with the carb. hanging off the reed plate in back, I'd start with 1 to 1-1/4 turns each.
 
1 - 2 of 2 Posts
Top