Hobbyist Forums banner
1 - 10 of 10 Posts

·
Registered
Joined
·
1,352 Posts
Discussion Starter · #1 ·
Today 2 of my bulbs on my trinity real time 2 tray went out is there anyway to replace them or do i have to buy a new tray? please help
 

·
Registered
Joined
·
70 Posts
The tray is no longer made by trinity so fixing it will be your only option. I am not sure what type of bulb is in it, but the tray should still discharge with out the bulb.
 

·
Registered
Joined
·
1,557 Posts
Wait 5 or so minutes after the last bulb goes out. They generally discharge at about the same rate. Are you dead shorting?
 

·
Registered
Joined
·
1,951 Posts
Because only one cell powers the bulb. If you get a higher voltage bulb it will never light up and you will never know if its working or not.
 

·
Registered
Joined
·
35 Posts
I would discharge those cells were the lights work first, and when they are done move the cells that havent been discharged to a pole were the lights work. Or jsut go buy anther one. :)
 
1 - 10 of 10 Posts
Top