Hobbyist Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
hello, Im in the process of customizing a 1:18 1969 mustang boss and trying to turn it into a mustang coupe, i found several donors like a 1969 cougar and cutting of the roof on both cars and using the roof on the cougar to mustang. now my question is can you solder or can you weld these diecast? im thinking if i weld it would certainly melt the diecast or is there another way of doing it.

thanks.
 

·
Registered
Joined
·
639 Posts
What camaros said. JB-Kwik Weld is the way to go. It will bond diecast metal together quite well. It's basicly a two part epoxy like substance thats pretty darn hard once dried. You can find it at most hardware stores as well as Wall Mart.
 

·
Registered
Joined
·
3 Posts
Discussion Starter #4
okay thanks, where can i buy this stuff? I'm assuming a hobby store correct? what would be a good way to cut this?
 

·
Registered
Joined
·
8,588 Posts
walmart. thay make a 4min a 10min and 24hr . buy the 10 minute one.
jewlers saw or dremal using a disk.
 
1 - 5 of 5 Posts
Top