There's supposed to be a lip above the saucer edge and below the saucer edge; the whole edge is recessed from the top piece and bottom piece. Hope that helps.
nx 01 help
i can`t get the saucer`s outer windows to fit right, is there supposed to be a lip left around the bottom saucer when they are glues on? please help..
1 - 2 of 2 Posts
1 - 2 of 2 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Hobbyist Forums
A forum community dedicated to all Hobbyists. Come join the discussion about die cast, models, slot cars, radio control vehicles, classifieds, swaps, and more!
Full Forum Listing
Recommended Communities
