Hobbyist Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2,887 Posts
Discussion Starter · #1 ·
I'm testing out electronics on my t4, and have foud an interesting problem. If I snap the steering back to center to quickly, my receiver loses power momentarily (the light does go out) and then switches back on. I've never seen this before, any ideas?

Yes, I've switched receivers. Same problem.
 

·
Registered
Joined
·
302 Posts
What speedo are you running? The servo might need 6.0 volts instead of 4.8. When you snap the steering back, it might be drawing too much power to keep everything running. You might have to have a speedo with a 6.0 V output for servos.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top