Strange, see if the magnet on the flywheel is ok, never had one fail, but have had them come off. Have a good one. Geo
I,m stumped
Says 6 hp Briggs engine on wood splitter,#s as follows 12Q802-0120-D102100856. Get intermitent spark i disconnected kill switch from unit all together and checkd again,same thing,pulled flywheel to check key,key was fine but replaced anyway,also cleaned rst from magnets and replaced,still no spark.Replaced ign. coil with brand newone,still nothing.Splitter belongs to neighbor who wanted me to look at it as i fool with this stuff a bit and he complained of gas spitting back thru carb while running and also bogging down.When i installed new coil it fired up but gas was spitting thru carb and i shut it off,now spark issues again.Iforgot to mention i did the busness card thing between fly wheel and coil.Carb. has no adjustment screws eitherI,M ABOUT TO DRINK A BEER AND I DONT DRINK!Someone school me on what to try next.Thanks
1 - 1 of 12 Posts
1 - 1 of 12 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Hobbyist Forums
A forum community dedicated to all Hobbyists. Come join the discussion about die cast, models, slot cars, radio control vehicles, classifieds, swaps, and more!
Full Forum Listing
Recommended Communities
