Hobbyist Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi everyone just wondering how to replace a blade adapter on my poulanpro lawn mower some how the plate and bolts got sheared off :(
Thanks, silver
 

·
Registered
Joined
·
73 Posts
is she stuck on there? WD40 my friend and tap around the blade adapter with a ballpeen hammer. if that don't get it a little heat might do the trick, a little mind you, don't get the crank so hot that it damages the seal. might want to check your flywheel key. may have sheared. :wave: also apply some neverseez when you install the new one
 

·
Registered
Joined
·
3,241 Posts
wd-40 is just a water displacer.. PB blaster would fare much better...

If that doesn't work, do heat it up and do watch out as you can burn the bottom crank seal... but take candle wax and melt it down there... then try knocking it off.
 
1 - 6 of 6 Posts
Top