Hobbyist Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
my dad and i have tried hitting it with a hammer and tried heating it up with a gas welder until red hot and it will not come off it is the plate that mounts the blade , i tried using oil and lubricant but the plate will not come off either any ideas anybody????
:(
 

·
Registered
Joined
·
6 Posts
you are talking about the blade block. most of the time when they are stuck that bad we cut them off . take an cut the side of the block up an down BUT do not cut to deep because you dont want to hit the crank. then take a chisel an beet it off.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #4 ·
hi

yes ive got it off now it turned out we had 2 just cut the plate and we are now left with just the pipe part still on the shaft but thats ok:) i can get it off now if i want to:) i cldnt get a saw to fit i there or a grinder so ive taken the plate off which then allowed me to remove the exhaust and engine mounting bracket which is what i need thanks for your help:D
 
1 - 4 of 4 Posts
Top