Hobbyist Forums banner

Esc Bec And 4 Cell.

933 views 7 replies 6 participants last post by  NCFRC 
#1 ·
will a esc with 5v bec be enough for 4 cell racing with a personal transponder ?
 
#5 ·
I don't think the 5volt bec would be an issue since a 4cell batt. only has 4.8 volts available. I think its the amps of the bec that is more important. I have 4 GTS controllers, I don't think you can beat them for the price. I've never had any problems with them but I don't run a PT.
 
#8 ·
If you solder in your batterys or use a connector ,,, just cut the end of your PT and solder dirrect to the speedcontroller wires .
That way you'll have plenty of current and the least amount of voltage loss to the PT.

Your bypassing the ESc and reciever but with only 4 cells your perfectly safe.

Their rated for 4-8 cells ,,,, but as the voltage drops at 4 cellls your probably borderline.

If you can afford the weight gain , buy a 6 volt reciever pack from Pro-Match and its about the size of a quarter and .6 oz.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top