Hobbyist Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
Have ended up with two 3HP Gasoline Edgers that run fine except - the shaft that holds the blade needs to be replaced on both. Can identify the bearing and the pulley size but dealers want to know the Brand of the unit to get part number of shaft. If anyone has a manual on their edger that the shaft size matchs the description below I would appreciate the Brand, Model and part number so I can get these things running. Both shafts are about 3 1/2" long, 1/2" diameter in center, stepped down to 3/8" on both ends for pulley and blade. Thanks
 

·
Registered
Joined
·
13 Posts
Discussion Starter · #3 ·
edger

Sorry, should have said in original post that no manufacturers name is on either edger. One is a tan color that I remember from some manufacturer but cannot recall who. Thanks for the question.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top