[Rentahusband]

Pretty sure the adjustment screws have limiter caps on them unless the previous owner removed them. If the caps have been removed, turn the screws clockwise until they stop. Do not turn them to tightly closed. Then back the screws out about 11/4 turns and start it. This should get it to at least run, then you can adjust the final settings as it is running at both idle and open throttle. If the limiter caps are still on, it should at least run and be able to be fine tuned within the cap range.

 

[Rentahusband]

Can you see the tip of the screw at all? Idle speed should be enough for it to idle fast enough so it does not die.