[Vinnie k]

Once again I would like to Announce that I am making a career change that will not allow for any time for me to race or handle the piston and shock shaft business at this time. This does not mean I am done for good by any means.
I just need to take care of my Family first and racing will come later.

I am proud to say that Bob's Motorsports will be taking full control over the Dual Groove Pistons and Shock Shafts for the Invader and Lightning Shocks.

Also they will be taking over the Sponsor for the Tri State Door prizes.


Please Contact Bob's Motorsports for the Invader and Lightning Dual Groove Piston and Shock Shaft's.

Jon 1-702-210-3963
Bob 1-702-210-3961

If you have any Questions you can still email or call me @
[email protected]

1-262-902-4369

Note: The pistons are designed to fit any 1/2 in inner diameter shock body and are threaded 10/32.

The Shafts will stay at the stock length for the invader and the lightning shocks which is 2 1/4 in end to end length and are also threaded 10/32.

The longer 2 1/2 in shafts that were made for the Jr and Pro1 shocks will no londer be made.

I do have two sets of Jr/Pro1 Dual groove pistons and shock shaft's left

also have 20 shafts with no pistons left for the Jr/Pro1's

Thanks

Vinnie

 

[Vinnie k]

I have had a few emails and calls about the Pistons and shafts. So after my little brake away from HT I figured I would bump this thread up.

If your looking for the SHAFT need the SHAFT want the SHAFT or not at all the SHAFT

It's One Call That's All

Thanks

Vinnie

AKA

The Shaftster:thumbsup:

 

[DMP_SMOKE]

:jest::jest::jest::jest: