Hobbyist Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1,594 Posts
Discussion Starter · #4 ·
looks nice what did you use for the exhaust?
Some 1/16 inner diameter metal tubing from the local hardware store. Goes for about .60 a foot. It's just what the dr ordered for exhaust. I used 1/8 for the Superbird and Chargers.

Only bad thing is it will break when I try the trick of putting smaller wire inside when bending tube so it doesn't flatten out, so it's not steel.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top