Hobbyist Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
675 Posts
Discussion Starter #1
Are there any reference sources out there? I have been following Charles Adams thread on his site, but need more.

Anybody have the old MPC kit handy and can take some measurements?

Cygnus Length, width, height, height of command tower and diameters, pinnace, engine lengths and diameters, forward observatory diameters and forward docking port.

Palomino overall height, hull diameter and height.

probably lots of other measurements later. Those dang things go for too much on<a href="http://rover.ebay.com/rover/1/711-1751-2978-71/1?AID=5463217&PID=1606754&mpre=http%3A//www.ebay.com"> eBay!</a>.
 

·
Premium Member
Joined
·
8,335 Posts
I might know someone w/a copy of the kit that's builtup. Will email and ask them....
 

·
Registered
Joined
·
391 Posts
I have one as well. The years have not been good to the old girl. A lot of the spires are missing and the command dome is missing. The Palomino is still with the kit so a size comparison is still possible. I don't any plans for the Cygnus but I do have two view picture from an old calender of the Palomino here:

http://s93.photobucket.com/albums/l52/enterprisefan/

If I can get my camera to hold a charge I'll see if I can down load some closeups. But remember it is a orginal model build many many many years ago by someone with very little modeling experience
 
1 - 5 of 5 Posts
Top