Hobbyist Forums banner
1 - 2 of 2 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I have a 26.2 cc craftsman (model: 234-795511) that won't start. Fuel Lines are new, sparkplug is not new but clean, tried removing air filter and spraying starting fluid in there. Should I pour some gas straight into the cylinder?

Haven't started this one in about a year but it did run last year OK. Actually it was a little out of adjustment last year... too much throttle would sometimes cause it to start to die and I'd have to "pump" the throttle switch to keep it going.

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.