Hobbyist Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
6,116 Posts
set low speed and high speed (load) adjustments to 1 1/2 turn from seat to start, after engine is running you will have to fine tune these adjustments. The idle stop screw does not have a set amount of turns, this is a stop screw and needs to be set for proper idle rpm's.
 

·
Registered
Joined
·
21 Posts
Discussion Starter · #3 ·
thank you, for your help.

i found these the settings on page 20 of the documentation in the 692509 tecumseh technicians handbook? Sorry to ask such basic questions, but i did not find it the first time i looked.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top