Hobbyist Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I have I think a toro s-200 I had my freind clean it. It only starts off primer after serval primes what could be the problem?
 

·
Registered
Joined
·
15 Posts
Chris, clean it again, after soaking in carb cleaner (or stabil) if you don,t have compressed air run a small wire thru all of the opening. There is something clogged.
jonsey
 

·
Registered
Joined
·
75 Posts
when cleaning your friend might of messed up the hi/lo idle speed needles tighten them in not to snug or you might damage the needle set then losen them 1 3/4 times each if you get it runnin just fine tune them till it idles
 
1 - 8 of 8 Posts
Top