Can anyone advise me as to what the correct inital adjustments (number of turns out) would be on both the high and low needles. This is a carb that has the non-slotted needles. that require a special tool to remove/adjust which I don't have. It does not appear to be either a Walbro or a Zama....maybe it is a Chinese made clone? I was able to get the needles out and cut slots in them so I can easily adjust them with a screwdriver going forward. Just not sure where I should set them. I set both @ 1.5 turns and got it to run.
Spit
Spit