Hobbyist Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
224 Posts
Discussion Starter #1
Hello again!
I'm just finishing up a 1:537 USS Reliant....i used the correction kit from DLM, but i've had to do some sanding where the new impulse part joins the rear hull....consequently, the black vents which are located at both rear corners of the ship have been obliterated! Can anyone provide a decal/graphic i can print out to replace these vent things?

Thanks chaps!
Rich
 

·
Registered
Joined
·
500 Posts
lizzybus said:
Hello again!
I'm just finishing up a 1:537 USS Reliant....i used the correction kit from DLM, but i've had to do some sanding where the new impulse part joins the rear hull....

Oh no you didn't. I do not make that aft end correction kit.


DLM
 
1 - 6 of 6 Posts
Top