Hobbyist Forums banner
1 - 1 of 1 Posts

· HobbyTalk Pro
Joined
·
2,347 Posts
Jones: If you have buggy shocks on it, use associated buggy springs: Start with golds on all 4 corners. #2 pistons in the front, #3 in the rear w/ 35 wt. oil. If the track is really loose, get a pair of 1 degree rear toe in suspension mounts as well...
25 degree caster both sides, 0 camber on all 4 to start...
Set the ride height so the rear arms are level, (parallel with the ground) with a motor, battery, etc. installed. Then set the front ride height so the chassis is level front to rear. Make sure you have the car "sitting into" the shock travel a little, so the suspension can go up or down while sitting at ride height. This should be a good starting setup, see what the car does from there...

Regards,
Todd Putnam
Putnam Propulsion
www.putnampropulsion.com
(518) 452-0422
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top