Hobbyist Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Sometime it will run for about 3 seconds. After you pull the cord about 3-4 times there seems to be prussure buid-up in the motor becuase from that point on the cord becomes to tight to pull. A few minutes later you can again pull the cord about 3 times and the same thing happens.

Any suggestions.
 

·
Registered
Joined
·
333 Posts
Try holding the trigger on the wand as you pull it over. Its building pressure in the pump that has no where to go and will not let the engine turn over.
 

·
Registered
Joined
·
8 Posts
Discussion Starter #3
Pressure Washer -Won't start

Someone suggested it might be a sticky valve. That gas is building up after a couple of pulls with no place to go. If so how do I repair this?
 
1 - 4 of 4 Posts
Top