Hobbyist Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter #1
I have a MTD tiller model 213-406-000 and i need to adjust the governor and cant seem to get it right I have inspected the carb and installed a new diaphram and gasket and it still runs wide open full throttle. I also bought a new spring because i notice that there was not on on the gov. any help will be greatly, greatly appriciated.

Thank you in advance.
 

·
Registered
Joined
·
38 Posts
Discussion Starter #3
I cant find it the engine model it had been painted befor I got it, it is however a early 90's Briggs and Stratton horizontal shaft engine. Thanks for asking
 
1 - 4 of 4 Posts
Top