Hobbyist Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
609 Posts
you can drill two holes about an inch and a half out from the shaft hole in the pully and use a long bolt with a nut on the bottom side of the flat home made puller woks good some of these pullys are 40 to 60 bucks , leave the bolt in the crankshaft just loosen it up about 5 good turns , some times what happens the key slot will wear and the key will roll over a little and it makes it a pain , i have ahd to grind them off b-4 like he said Patience, what kind of mower is it ?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top