Hobbyist Forums banner
1 - 2 of 2 Posts

4 Posts
Discussion Starter · #1 ·
I have a Snapper NXT 22875E (B&S 12S907-0141-B1) that has developed a stress split in top of gas tank. The stressed split starts where round hole for gas gage was cut. It runs about 3/4" toward
top out side of tank. I pulled the gas gage out of tank & noticed there was not any reinforcement where the hole was cut.

Has anyone else had this gas tank problem?

Thanks, Redhead#01

PS: Is there any B&S Gas Tank Recalls?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.