Hobbyist Forums banner
1 - 1 of 3 Posts

· Registered
20 Posts
Re: briggs pulley.

Pretty easy to get another pulley: just measure the circumference, how wide the shaft is, how wide the keyway ( the slot in the crank) and order one to that spec. For example, let's say the pulley is 3" with a 5/8" shaft and 3/16th keyway. What you would look for is ID: Interior diameter ( the hole in the midle) OD: Outer diameter ( the width of the entire pulley) and the keyway- measure the width of the gap where the key goes. good luck.
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.