5 Hp Briggs New Coil--wont fire
Hi Folks
I bought a new coil and found that points and condensor are no longer needed. I followed the directions, which except for plugging the plunger hole, is to just mount the coil. I cleaned the magnet an installed the flywheel. No Spark. I purposely left off the ground cut off leads until I knew it was firing. I tried adjusting the gap between the magnet and coil a couple of times , but still No Luck. Any ideas?
I bought a new coil and found that points and condensor are no longer needed. I followed the directions, which except for plugging the plunger hole, is to just mount the coil. I cleaned the magnet an installed the flywheel. No Spark. I purposely left off the ground cut off leads until I knew it was firing. I tried adjusting the gap between the magnet and coil a couple of times , but still No Luck. Any ideas?
1 - 1 of 1 Posts
1 - 1 of 1 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Hobbyist Forums
A forum community dedicated to all Hobbyists. Come join the discussion about die cast, models, slot cars, radio control vehicles, classifieds, swaps, and more!
Full Forum Listing
Recommended Communities
