Hobbyist Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
6,122 Posts
Oil can get in there a number of ways. Check the oil level make sure it is not overfull, check the air filter make sure there is not any oil in there or in the carburetor where the breather tube connects. Oil helps lubricate and seal the cylinder area, so if the rings have sufficient wear oil can get past them even though there is enough compression for the engine to run.

Good Luck
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top