Hobbyist Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 9 Results
  1. Small Engine Repair General Discussion
    hellow i have a 297cc briggs and stratton motor i dont know the hp it says 18hOhv on the side but its not a 18hp im trying to figure it out i have all the model # and the shaft is a solid 7/8" bore do i need a key way for a clutch ? please reply asap
  2. Small Engine Repair General Discussion
    I have a small string trimmer engine that I'm taking apart, and I cannot figure out how to get the screws out to separate the top and bottom sections of the engine. Here is a pic, the screw in the pic has another one diagonally across from it in the same position, and I can't figure out how to...
  3. Small Engine Repair 4-Cycle
    I have a generac generator with a Tecumseh HM100 engine. It will start with half a pull when its cold and run beautifully...will not start when it is hot. Since, have replaced spark plug, magneto, carb, and done a compression test. It will hold 150 psi hot or cold,but I noticed anything under...
  4. Small Engine Repair General Discussion
    I have a generac generator with a Tecumseh HM100 engine. It will start with half a pull when its cold and run beautifully...will not start when it is hot. Since, have replaced spark plug, magneto, carb, and done a compression test. It will hold 150 psi hot or cold,but I noticed anything under...
  5. Small Engine Repair General Discussion
    I bought an 80cc motor kit off ebay from "boygofast" 80cc Bicycle Engine Motor Kit Motorized bike silver small mount slant head Z80S and have been having problems and I would like to figure out the solution before I blow the motor the motor. when I first started it (stock carb) it would run...
  6. Small Engine Repair 4-Cycle
    I bought a 7 hp h70 tecumseh snowblower engine but its not working. I cleaned the carb completly (even the small holes in the "screw") and turned the needle valve with the opened end toward the air intake. The guy that sold it to me said that he putted a new carb kit in it but that 1 seal was...
  7. Model Lights and Lighting
    Madman Lighting is pleased to announce our latest kit: The T-65 Engine and Cockpit lighting kit for 1/48, studio scale and larger X-Wing kits. This kit features flickering red engine lights and a wide collection of colors and patterns to light your cockpit and droid lights. Landing lights are...
  8. Small Engine Repair 4-Cycle
    i have a Dewalt gas air compressor, it has a 4 stroke engine on it, it ran a bit ruff a while back, and now it wont start at all, if i pull the cord 6-7 times a large flame and pop comes out of the exhaust on the 7th pull, I have asked a few places and they said it could be anything from bad...
1-8 of 9 Results
Top