McCulloch MAC 3200 Chainsaw Fuel Lines - HobbyTalk
  
HobbyTalk Forum for Diecast Collectors, Modelers, Slot Cars, & Radio Control
Home Forums Photo Album RC TrackFinder Catalog Donation/HobbyTalk Supporter

Welcome to the HobbyTalk forums.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, view attachments, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact contact us. Forgotten your password? Click here!

NOTE: Once you register and are logged in this welcome section will no longer be visible.

Go Back   HobbyTalk > Small Engine Repair > Small Engine Repair General Discussion
Register Classifieds Help/TOS Members List Calendar Mark Forums Read

Reply
 
Thread Tools
  #1  
Old 09-16-2009, 05:37 PM
maxbowen maxbowen is offline
New Member

My Photos
 
Join Date: Sep 2009
Posts: 2
McCulloch MAC 3200 Chainsaw Fuel Lines

A friend gave me a MAC 3200 Chainsaw that looked new and when I filled it up with fuel oil mixture it ran great for about 10 minutes and then would not start. The two fuel lines in the gas tank came apart in several pieces and were in the bottom of the fuel tank. I can not figure the routing of the two fuel lines.

I know that one fuel line went to the primer bulb. Does this primer bulb line have the filter - weight installed to the end of the gas line in the Tank?

Where does the other line from the the walbro carb go into the gas tank -- is this line a air vent for the carb or an inlet for the carb?

I hooked up the primer bulb to the filter - weight in the bottom of the tank and the other fuel line as an air vent line. The chainsaw would start and run about 30 seconds using the primer bulb. I then hooked up the filter - weight to the other line at the carb and the chainsaw will not start -- it is flooded.
Reply With Quote

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


Featured Sponsor
You Can Sponsor
A HobbyTalk Forum


HobbyTalk® Sponsors
Diecast
CScollectibles
Collectables Corner
DieCast Alley
Global Diecast Direct
Milezone
Mini-Motors Inc
Scoomer
The Toy Peddler
Toy Car Aution
Models
MegaHobby
Modeler’s Brand
ParaGrafix Modeling Systems
Radio Control
BeachRC.com
B-Fast RC
Dirt Cheap RC
Discount RC Tires
Irrgang Racing Service
Lefthander RC
MaxAmps.com
RCTV Live
SMC Racing
Speedzone
Thunder Racing
Tekin
Trend Times
TQ Racing
Windtunnel Racing
Slot Cars
AFX Racing
Scoomer
Slot Magazine
Sponsored Events

Become a
HobbyTalk® Supporter

Advertise on HobbyTalk®



Powered by vBulletin®
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
All times are GMT -4. The time now is 12:13 AM.
HobbyTalk® is a Registered Trademark of HobbyTalk Ltd.
All other logos and trademarks on this site are property of their respective owner.
Copyright (c) 1997-2012 HobbyTalk Ltd. No use without permission.
Advertising positioning by Digital Point