Went to use my homelite chainsaw--it starts (kind of hard)
but at full throttle shuts down, like its starving for gas. I cleaned the plug and put new fuel in but no change. I had the old gas in all winter. Any ideas?
Thanks for the reply. I only see 2 needles, 1 was for idle so I tries to open up (counter-clockwise) the other needle and was fully out all ready. Am I missing the boat here ? (lol) Thanks--I need all the help I can Get.
Kev
You should have 3 screws actually. One idle and two mixture screws. If you take the top off the saw you should see the two mixture screws side-by-side on the carb. The mixture screws have limiter caps that you can take off (normally with needle nose plyers).
Thanks again for your reply. I will check it out tonight!
Kev
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Hobbyist Forums
4.3M posts
95.3K members
Since 2000
A forum community dedicated to all Hobbyists. Come join the discussion about die cast, models, slot cars, radio control vehicles, classifieds, swaps, and more!