I've got a GFX and I'm trying to cycle packs to see what the numbers come up to. The only problem is I can't seem to get things set right. Does anyone know what I should be setting all of my cooldown times and all of that other stuff at to get the right numbers? Any help would be appreciated, thank you Michael

This has been covered before, i a few diff threads. Hear it is again. set number of peaks to 2, first peak detect .05 (6 cells) .03 (4 cells), 6 amp charge and repeak .01, leave delay alone 120 seconds default from factory, discharge amp 30 or 35, end voltage 5.40 (6 cells) 3.60 (4 cells), no flex charging standard discharge mode. you will need to make sure the cells are all discharged to the same point, not on a buld discharger but a tray. if your cells aren't matching the labels then you hurt the cells some way, there old or you got ripped off. the most important thing is the small voltage senseing wires you have to use them connected to the battery bars not the large charging leads

Thanks alot for your help, Michael