i want to put a receiver pack n my oval car but would like to use only one switch any suggestions????????or pics

Remove the red wire from your ESC to receiver connection and put the switch in the receiver pack wiring.

I have the same question, but is it bad to connect both power supplies (bec from esc and rx pack) to the RX?

another question:
If you pull the red wire out of the esc-rx plug, what does the esc switch do? Does it still need to be used on the car? If so, there will be two switches: RX pack and esc. With a seperate RX pack, could the esc switch just be cut off and the wires soldered together, like if the switch was always on?
I guess this is getting to be a poll....what do other racers do in this situation?

i've done the reciever pack with Gm v12xc's and it needed both switches with the removal of the + wire from the plug. i just changed over to the novak GTX and it only uses the reciever pack switch, and no removal of the + wire in the plug.