Hello,

I have heard to do a full body wrap with decals it is best to use a template of each side and top of the vehicle and then make several decals out of the same pic but different parts. Does anyone have a template for the 67/68 Firebird?
I have tried to scan the casting itself but it always scans way bigger and the scanner does not have a setting that I can find.

Thanks,
Steve

i have heard of people tracing the body out on paper then transfering what ever there putting on the car to it and rescanning then cut out a template. but if i were you you might ask pm on the jl board he might beable to give you a better answer. hope this helps later gunn

Maybe you could wrap the car tightly with one piece of either plastic wrap or Glad press 'n' seal wrap, trace the desired pattern with a sharpie and then carefully remove it from the car and place it flat on paper. Then scan, copy or trace it onto another piece of paper. Don't know if it'll work, but the stuff is probably in your kitchen. Just an idea.
As Gunn suggested, you might try to contact someone at PM. That sounds like a good idea. :wave:

Maybe you could wrap the car tightly with one piece of either plastic wrap or Glad press 'n' seal wrap, trace the desired pattern with a sharpie and then carefully remove it from the car and place it flat on paper. Then scan, copy or trace it onto another piece of paper. Don't know if it'll work, but the stuff is probably in your kitchen. Just an idea.
As Gunn suggested, you might try to contact someone at PM. That sounds like a good idea. :wave:

sorry im used to calling him pm in the chat room. dont contact pm thay wont tell you anything.
try contacting pms485 on the jl board im sure he can help you. :wave: