Best settings for 13.5 1c......Whats your opinion ?

Depends on the motor your running. I am running a Novak SS motor at full timing with profile 6. Have had very good results with it.

Thanks Casper for your time. I am running the ss motor with full timing also. But i am running a duo motor in my cot car. Anyone care to chime in on this subject ?

I'll tell you more about the Duo after Tuesday.... I just dropped one in the car to play with.

Thanks again.....

I have seen profile 4 work with 10 degrees with Dou ,It isnt as fast up front but comes on strong at 2 minutes .....SRM

What is the difference between the Dou and the Ballistic with the timing?

I have tried a bunch of different stuff with the Ballistic and the SPX.

Right now I'm at full timing on the motor tab and mode 7 on the speedo. Very low rollout.

The Ballistic in the center of the timing label is 30 degrees. So you are running 10 in the motor and mode 4?

Yes 10 in the motor and 4 on the profile ...SRM

WOW, I must be running mine with a lot of timing. I'll try your setup this Saturday. I know when I was running the motor in the middle of the timing tab(15 degrees) and in mode 6, my motor wouldn't get over 118 degrees. I know we can't set rollout by temp anymore, but the car was a little faster with more timing and the motor around 130 degrees. Myt friends that run the Tekin are coming off over 160 degrees.

Thanks for the info.

You can put more gear on in the profile 4 and still be faster the last 2 minutes ... 1 cell is more about chassis and conserving battery so your fast the last of the race SRM

Well Saturday I ran my SPX in mode 4 and backed the motor down to 10 degrees. First run I ran the rollout the same and the car was about a tenth and a half per lap slower. Next run I went up 5 teeth and picked it right up. The laps only fell off a tenth from start to finish. Last run I went up 1 more tooth and the car was faster and dropped off only about a tenth and a half. Motor temp only got to 130. All this is on a short track only 36x65. Next week we'll be racing at a bigger track and more testing.

What are you guys using for 10.5 ballistic motor setting wise?And anywhere to get the mode programing inst?The set I have is in german I think?:freak:

Thanks Jake

We haven''t run the 10.5s except in Cincinnati where we both were terrible.

I can copy and send you the setup sheet for the speedo if there aren't on the website.

We haven''t run the 10.5s except in Cincinnati where we both were terrible.

I can copy and send you the setup sheet for the speedo if there aren't on the website.

That would be great. jakewitt@sbcglobal.net

Jake

Hey Jake, how about I just bring them Sunday?

Hey Jake, how about I just bring them Sunday?

Sounds good thanks

Jake

I am considering buying a spx for my hyperdrive pro 4 car. We are running 13.5 1 cell cars. I am thinking about the Trinity Nemisis motor. Any thoughts on that combo?

I am considering buying a spx for my hyperdrive pro 4 car. We are running 13.5 1 cell cars. I am thinking about the Trinity Nemisis motor. Any thoughts on that combo?

I'm using the SPX with the Novak Ballistic motor.:thumbsup:

What are your setting on Mode 6 using a Duo 2 motor on a 150' driveline?