where i can find the information about what i need to convert my turbodyno to check brushless....i have seen a post about someone who have make the conversion...but i can't find it anymore

thanks

Pace

It all works the same ,,,you just use the motor leads on the dyno as battery leads to your speed control. you will set up with a receiver and speedo and use your transmitter. just like a dyno pull on a full size car, start the dyno and then pull full throlltle.

http://www.hobbytalk.com/bbs1/showthread.php?t=246201&highlight=Turbo+Dyno

http://www.hobbytalk.com/bbs1/showthread.php?t=246201

you can rig it up so a transmitter is not needed. you just need a servo tester

look here

http://www.hobbytalk.com/bbs1/showthread.php?t=246201&highlight=brushless+dyno

as posted in 405, it uses the servo tester.