View Full Version : 7.5 1Cell Rollout?


dom3669
10-06-2009, 08:56 PM
Looking to try / run 7.5 1 cell in a week or so... Need help on where to start with roll out. will be running 7.5 ballistic with a tekin rs . Runline about 180ft. any suggestions would be great.....

Dom

jake86
10-07-2009, 05:17 PM
Dom try around 3.00 rollout that should get you close.

Jason

Racin Steve
10-07-2009, 08:00 PM
Looking to try / run 7.5 1 cell in a week or so... Need help on where to start with roll out. will be running 7.5 ballistic with a tekin rs . Runline about 180ft. any suggestions would be great.....

Dom

I suggest you try these settings with the 7.5 ...

Dual Mode / timing Advance set at 100

Minimum timing on the motor

3.20 rollout.

Steve.

dom3669
10-07-2009, 10:49 PM
thanks guys...

Steve whats the deal with dual mode? 7.5 dont like timing boost?

Racin Steve
10-08-2009, 07:23 AM
thanks guys...

Steve whats the deal with dual mode? 7.5 dont like timing boost?

Low winds motor are more efficient in dual mode ... try it out.

Steve.

dom3669
10-08-2009, 11:00 AM
I will, Thanks Again.....:thumbsup:

dom3669
10-18-2009, 06:58 PM
Steve, you were right on, worked great..... Thanks Again...

Dominic.

indy-25
10-19-2009, 10:57 PM
In dual-mode the timing on the motor does not factor into performance.

Racin Steve
10-19-2009, 11:20 PM
In dual-mode the timing on the motor does not factor into performance.

You're right.

But, from a dead stop (0 rpm) the car gets rolling using the the sensor wire and motor timing.

Steve.
team Tekin

Bill Spicer
11-08-2009, 09:12 PM
Steve, do you consider minimum timing the setting that Novak sets it at.

Racin Steve
11-08-2009, 11:40 PM
Steve, do you consider minimum timing the setting that Novak sets it at.

The minimum timing is ring full clockwise.

Steve.

EAMotorsports
11-08-2009, 11:47 PM
The minimum timing is ring full clockwise.

Steve.

Hey Steve,

Bill may be talking about the Novak Ballistic motor. They dont have stops on the timing adjustment...it will spin all the way around...LOL. The N on them is about 30 degrees. Each notch is 5 degrees and they dont recommend going below the - mark.

EA