I have an old 10hp Tecumseh and need a needle seat and float bowl gasket ring. The only numbers on the carb are 511 2B8. Can anyone give me cross referance # to find a rebuild kit. I cannot find anything from those numbers.
Thanks,

whats the model and type numbers stamped into the shroud?

There are no number stamped anywhere that I can see. There is a Tecumseh sticker on the recoil shroud. I will try to get a picture posted. This is an old engine I am guessing 20+ years.

The main parts I need are the needle seat, bowl gasket, and main jet high speed screw rubber o-ring (bottom of bowl). It runs good, just cant keep the rubber o-ring from leaking. The float needle valve actually sticks into the needle seat and "pops" in and out. However, it does stop gas and seams to run ok with the sticking.

Are part very interchangable between kits (needle seat).

Any ideas on the o-ring, it appears to be sealling tight, I just think gas is getting between the o-ring and threads on the main jet needle.

Thank,
Jeff

does it have the fuel tank mounted on top of the shroud? if it does the numbers you need are probably stamped in the shroud under the tank.

may be one of the two kits at the bottom of this page.

http://www.outdoordistributors.com/Tecumseh/tfuel.html

I just think gas is getting between the o-ring and threads on the main jet needle.

I was registered at your forum. I have printed the test message. Do not delete, please.

One more late congrats! I hope you had a good one!

Demande comparatif taux pret immobilier actuel | (http://tauxpretimmobilier.net)Estimation calcul credit interet financement immobilier | (http://tauxpretimmobilier.net)Offre comparaison taux prets immo (http://tauxpretimmobilier.net/taux-pret-immobilier/)

hd4ou
How do I know which carb kit is correct? I cannot find any number other than those shown on the carb. Here are some pics.

Jeff

Here is one more picture.

Post all the numbers off of the carburetor as they can be cross referenced to the correct carburetor and kit.