View Full Version : B&S engine question


melvin3168
08-22-2009, 01:41 PM
i have a toro lawn mower with a B&S engine mod # 95902 type 3152-01
code 93010705 just up and died no spark replaced the armature magneto
still no spark. removed the fly wheel all looked good key in place. where do
i go from here. thanks gabe

30yearTech
08-22-2009, 08:10 PM
Make sure the new module is installed in the correct orientation and the air gap is set properly. Disconnect the kill switch lead and retest for spark.

melvin3168
08-28-2009, 01:12 PM
i did ddisconnect the kill switch still no spark . i will get the pictures you want to you
soon.

gabe

tractionroller
08-28-2009, 07:27 PM
did you set the air gap between the coil and flywheel?

Lawnmowertech
08-29-2009, 02:57 PM
melvin i left you a reply in your other thread concerning this

seazning
09-02-2009, 01:25 AM
My Poulan Weedeater lawntractor is running ruff. Its starts but runs hi and low.

Lawnmowertech
09-02-2009, 11:16 AM
My Poulan Weedeater lawntractor is running ruff. Its starts but runs hi and low.


this can be caused by many different things carb ignition timing it all can cause surge problems with the engine need to know some more symptoms to have a clue as to where to look at for the problem

calvin

seazning
09-11-2009, 12:17 AM
This lawntractor is a 18 hp b and s twin cam. When I take it out for a ride, and it leans to the left on a hill it starts racing up and down like its running out of gas. I get it on the the level and it runs fine.