I was just wondering what the height of a block would be for checking the ride height for a wcm sportsman would be or what someone may have found that works. I would like to make or buy some but not to sure about the height. Thanks

Vinney: You have PM.:wave:

I was just wondering what the height of a block would be for checking the ride height for a wcm sportsman would be or what someone may have found that works. I would like to make or buy some but not to sure about the height. Thanks

I made some at 5/8 " for a starting point

I was just wondering what the height of a block would be for checking the ride height for a wcm sportsman would be or what someone may have found that works. I would like to make or buy some but not to sure about the height. Thanks

I was wanting to know the same thing . I seen Smoke use some blocks that he made and with a tire cap under them when setting up Ed`s car .

I believe hpi or rpm makes some for dirt or touring cars me myself I just use tape measure

make them out of wood about 3/4 on one side and a inch the other way:thumbsup:

If you are good with a saw,
take a block of wood and cut steps at 1/2, 5/8, 3/4, 7/8, 1 inch.

I do not think any more are needed...

Chuck #3

Thanks everyone for the input, just would like to know where i am at with this car and keep up with it.