Just started assembly on the mini-Lost in Space Robot kit... any ideas regarding filling that annoying seam down the sides of the feet without screwing up the rib detail?

Use enough glue to form a small bead. Let cure completly. Use jewelers file very carefully. Trick is cure time - do not rush it!

Mark Dean

Sand till the detail is gone. Use Evergreen strip to replace it. That was my solution.

May have to go that route, Duct.... mine seems to have a slight "sink" around the seam. Only other option I have is to work some Aves down in there & smooth it out with a tiny brush & Aves solvent.

Also just noticed that I'll need to cut a small square of thin sheet plastic to add the power pack to the robot's side.

Sand till the detail is gone. Use Evergreen strip to replace it. That was my solution.

Thats what I did also... was easier, and neater