Hello all. I have a B&S 12 HP engine riding mower. I am rebuilding the carb. I need to know how to remove the seat from the carb. It is a brass press in seat. No slot for screw driver to twist it. Is there a trick to this procedure?

Your help is appreciated.
Thank you.

Engine 281707-0137-01
gravity fed fuel

Check the picture below, you use the old one to install the new one. Have a good one. Geo
http://i190.photobucket.com/albums/z120/geogrubb/Seat-1.jpg

Thanks for the response. I had thought about that method but, didn't think that would be right. I will give it a try and let you know how it works out.

Thanks again.