Mounting up my new ProtoForm TCC body, found I had to REALLY raise the height of the body mounts. Might even have to get some new (longer) ones. TOUR rules state that running this body in 13.5 1-cell, body must be cut on the body trim lines. You can't slam this thing...LOL

Also found I had to really trim back the bumper foam to get it to fit under the valance/splitter, and it still sticks underneath a little bit, pushing up the nose of the body just a bit.

Just got my tcc body. TOUR rules call for no cutting out of the rear. The spoiler mold into the back goes about 1/8th inch above the line for the bumper. Trying to cut this to the Line would leave a mild role out on the bumper and is going to be a difficulte cut to make. Maybe this should be talked about over in the TOUR section on how much will be allowed for this.

The spoiler mold into the back goes about 1/8th inch above the line for the bumper.Are you talking about in the rear of the body, where the separate wing is molded into the Lexan?

I didn't cut out any of the rear of the body at all; cut right along the molded cut line all the way around. Doing this, I had to adjust the height of my body mounts quite a bit to get the ride height the same as my "non-CoT" body (I call it my "Late Model" body, because that's what it looks like...:)).

Once I get my GTB and 13.5, I'll do some testing with it.

[quote=JimmyMack12;2883410]Are you talking about in the rear of the body, where the separate wing is molded into the Lexan?
Thats is what I am talking about.