Ok I cannot afford two cars at the moment, almost decided to keep it but with my son now getting into rc one car for me and one car for him and that is all. So with that said this has to go. This is a package deal and prefer not to break it up. I am asking $645 plus shipping. Tons of new parts worth over $250 plus extra parts.
I recommend replacing the Kydex bumper as I have had it over 6 months and think it is time to replace and can be found here for $10 and way better than the carbon fiber one that goes for $25 http://www.manutech.info/rcracinghome/racingproducts.html

The car is currently setup 200mm but with the extension kit you can set it up to 235mm setup for pro10 or keep it 200mm for World GT.

The used tires seen at the end have some chunking but since they have never been trued there is a chance you can true them and still be used. Some are ok but they are part of the package and just including them.

Also I am including some nimh batteries I literally got last week with a deal for a tc5r and have no use for them since I am running lipo. See the last picture for details of the life of the batteries. NOTE: If you take the batteries be aware that they will add an additional 6lbs to the package.

Box weighs 8lbs without the nimh batteries (add another 6lbs if you take the nimh batteries).measures 7 x 11 x 11 and ships from zip 90032.



Paypal prefered

Gen X 10 $200
Novak GTB w/lipo cutoff $140
JR Z3650 $40
Spektrum sr3000 $40
Losi Lipo Steel plate $15
235mm Extension $25
Extra Chassis $25
Yea Racing 3200mah lipos x 2 $35 both have 4 dozen plus runs have always been balanced on every charge.
Novak 3.5r seeing better days cosmetically but mechanically it works great.
Novak 10.5 bought used and works well.
two 235mm Protoform p905 bodies used
one 200mm Protoform Mulsanne used
New CRC Gen X 10 foam bumper never used.

Over $250 worth in new stuff:

# All new in bag below: Retail Price
1) Left clamp hub $24.99
1) ride hieght spacers $2.99
3) Aerodiff spacer collar $1.99 each x 3
1) Large D Diff Rings $1.99
1) Graphite Steering Arms $4.99
1) One piece links $1.99
2) Belleville Spring Washers $1.99 x 2
1) Brass 4-40 set screws $2.99
1) Front Hinge Pin Teflon $1.99
2) CRC King Pin $3.99 x 2
1) Steering block set $4.99
2) CRC Dual Front Axle $6.99 One bag opened but new
2) CRC Large Diff D-Ring Axle $21.49 x 2 one set just installed and used Friday for one race the second one is still sealed in the bag. two shown sealed but one has been installed last week.
1) Low profile pivot ball $4.99
1) FE Hinge pin $2.99
2) Steel T-Bar pivot Ball
1) CRC 3/16x5/16" Flanged Ball Bearing (10) $21.49
1) CRC 1/4x3/8" Flanged Axle Bearings (10) $21.49
1) CRC 1/4x3/8" Unflanged Axle Bearings $16.99
1 x Jaco World GT Spec Tire, Rear (Lilac) (2) (JAC2110) = $14.49
1 x Jaco World GT Spec Tire, Front (Lilac) (2) (JAC2100) = $11.75
1) Jaco AeroForce Rear Mounted Foam Pink $18.79 (Just taken out Friday and used once)
1) Jaco Racing AeroForce Front Mounted Foam Purple $16.49
1) Jaco Racing AeroForce Front Mounted Foam Pink $16.49 (Just taken out Friday and used once)
1) CRC Flame Logo T-shirt - Black, Large $15.99 (New sealed in plastic)
2) Associated Steel T-Bar pivot ball $1.99 x 2



Installed Hop Ups:
Graphite Front Stiffener
1/8" (12) Ceramic Nitride Pro Series Differential Balls (from Nexus)
Bronze Pivot Balls - Pro-Strut Lower Arm
CRC Molded Center Pivot
Option Wide Body Mount for Gen-X 10 $14.99
LOSI Steel lipo plate


Used:
Novak GTB with lipo cut off
Novak 10.5 Brushless Motor
Novak 3.5r Brushless Motor
JR Z3650 Digital Hi-Speed Mini Race Servo $69.99
Spektrum SR3000 2.4ghz
235mm Hub Extension $37.99 (Prevously installed)
extra chassis $59 value
2 x Yea Racing lipo 3200mah 20c
Graphite Side Plate $9.99 x 2
left hand clamp used
1/8 E-clips-100 pieces opened
3/16 shim (fits GenX/Pro Strut FE)
1/4 Shim Set
springs

http://64.182.121.81/crc/genx10/P6020197.JPG

http://64.182.121.81/crc/genx10/P6020196.JPG

http://64.182.121.81/crc/genx10/P6020198.JPG

http://64.182.121.81/crc/genx10/P6020199.JPG

http://64.182.121.81/crc/genx10/P6020200.JPG

http://64.182.121.81/crc/genx10/P6020201.JPG

http://64.182.121.81/crc/genx10/P6020202.JPG

http://64.182.121.81/crc/genx10/P6020195.JPG

http://64.182.121.81/crc/genx10/P6010191.JPG

http://64.182.121.81/crc/genx10/P6010178.JPG

http://64.182.121.81/crc/genx10/P6010177.JPG

http://64.182.121.81/crc/genx10/P6010184.JPG

http://64.182.121.81/crc/genx10/P6010187.JPG

http://64.182.121.81/crc/genx10/P6020204.JPG

http://64.182.121.81/crc/genx10/P6020206.JPG

I just got these batteries with a tc5r I just bought last week and here is the email from the seller of the condition of the batteries if you want them.

************************************************** ************************************************** **
The Batteries. I consider them practice packs, not competition packs. The 3300's are great and hold up well. The 4200's are only great when the are in their 1st month or two of existance. Random cells tend to die abruptly, so I would do this: Check each cell with a volt meter and determine which one's are below 1.00volts. these are usally the bad ones. Take the remaining good ones and build a good pack. Trust me, I've done it a hundred times.

NOTE: If you take the batteries be aware that they will add an additional 6lbs to the package.

http://64.182.121.81/crc/genx10/P6080184.JPG

Can This Car Be Used For "world Gt"

This is a World GT car and all you need is the protoform Sophia body wich would be ideal for best performance. Here are the roar info from www.worldgtrc.com

Chassis
1) Suspension
a) Front End must be “sliding king pin style”. No independent A-Arms.
b) Rear End must be “solid straight axle with integral differential”.
2) Width 200mm at maximum
3) Wheelbase (length) must be within 10” to 10.5”, axle center to axle center.
4) Weight minimum (Ready to Run with body) = 1106 grams - NiMh, or 930 grams – LiPo.
5) Minimum Ride Height 4mm (Ground to underneath Chassis)
6) Roll Over antennas are not allowed
Body
1) Maximum Width 205mm
2) Minimum Roof Height (Ready to Run) 104mm
3) Wing Max Width 200mm
4) Wing Max Chord 45mm
5) Wing Max Side Dam 45mm x 20mm
6) Wing must be fastened to the rear deck of the body
7) Rear Wing may not be higher than roof height
8) The rear of the body must be trimmed no more than 40mm higher than the ground level with the body mounted.
9) Approved World GT Body List
1. Protoform Chevy Corvette C6 #1499
2. Protoform Sophia #1502
3. Protoform Gianna GT # to be announced in July 09
4. Parma DB9 GT # 10225
5. HPI Toyota Supra GT #7486
6. HPI Dodge Viper GTS-R #7473
7. HPI Mazda RX8 #7488
8. HPI Saleen Mustang #7428
9. HPI Nissan R34 GT-R #7427
10. McAllister Ferrari 599 GTB Fiorano #257
10) Bodies must be based on production front engine – rear drive autos.
11) Minimum body material thickness .030”
12) Minimum dimension, center base of windshield to intersection of hood and front grill 135mm
13) Minimum width at the base of the windshield 145mm
Power
1) Battery – 4-Cell Ni-MH or single cell lipo*
Approved Battery List:
1) SMC #SUM4025S
2) Motor – Approved 13.5 Brushless
Tires/Rims
1) Jaco World GT Spec Tire
Lilac Front Control tire #JAC2100
Lilac Rear Control Tire #JAC2110
2) BSR World GT Spec Tire
Lilac Front Control Tire #F1033-GT
Lilac Rear Control Tire #F1034-GT
3) CRC
World GT Front Spec Tire #2300
World GT Rear Spec Tire #2302
Race Duration
1) World GT races will be 6 minutes in length
* Single cell LiPo and NiMH powered cars are not to be run together

Sorry Just Read The Post Again, Your Willing To Sell The Car Seperate?

as in as a roller or with electronics?

Roller W/servo

I'll let it go with the spare parts.

How Much With The Spare Parts?

$480 broken down below.

Gen X 10 $200
Spare parts w/extra chassis $225
JR $40
Losi Steel plate $15

# All new in bag below: Retail Price
1) Left clamp hub $24.99
1) ride hieght spacers $2.99
3) Aerodiff spacer collar $1.99 each x 3
1) Large D Diff Rings $1.99
1) Graphite Steering Arms $4.99
1) One piece links $1.99
2) Belleville Spring Washers $1.99 x 2
1) Brass 4-40 set screws $2.99
1) Front Hinge Pin Teflon $1.99
2) CRC King Pin $3.99 x 2
1) Steering block set $4.99
2) CRC Dual Front Axle $6.99 One bag opened but new
2) CRC Large Diff D-Ring Axle $21.49 x 2 one set just installed and used Friday for one race the second one is still sealed in the bag. two shown sealed but one has been installed last week.
1) Low profile pivot ball $4.99
1) FE Hinge pin $2.99
2) Steel T-Bar pivot Ball
1) CRC 3/16x5/16" Flanged Ball Bearing (10) $21.49
1) CRC 1/4x3/8" Flanged Axle Bearings (10) $21.49
1) CRC 1/4x3/8" Unflanged Axle Bearings $16.99
1 x Jaco World GT Spec Tire, Rear (Lilac) (2) (JAC2110) = $14.49
1 x Jaco World GT Spec Tire, Front (Lilac) (2) (JAC2100) = $11.75
1) Jaco AeroForce Rear Mounted Foam Pink $18.79 (Just taken out Friday and used once)
1) Jaco Racing AeroForce Front Mounted Foam Purple $16.49
1) Jaco Racing AeroForce Front Mounted Foam Pink $16.49 (Just taken out Friday and used once)
1) CRC Flame Logo T-shirt - Black, Large $15.99 (New sealed in plastic)
2) Associated Steel T-Bar pivot ball $1.99 x 2

Price lowered to $645 for everything

Jerzy Jayro your pm is full and cannot send any more. Please clear out some messages and get back to me.

Its Clear Shoot

No longer available.