Ok heres my thought. I have a 1/10 slider and battery removal is a pain in the A$$ to say the least.

Can I put a Y in my chargin lead from the battery and not fry my ESC when charging the battery.

butch beebe has his setup like that. he put two bannana plugs in the side of his body and plugs his charger in to charge. probably have to make sure switch is off. on mine i just lift the body up enough to unplug. i left my wires long.

Some racers around here cut the body top plate into two pieces. They then remove only the rear half.

If you trim the body panel where it fits around the roll bar, it isn't that hard to remove. I always twist mine to the side and it pops out.

deans plugs to esc and little longer wire on battry side unplug charge plug back in sweet simple ..