I'm trying to wire up an Aurora Tjet steering wheel controller to my custom built track. The track is wired now for 2 alligator clips to connect the controller. My steering wheel has 4 screws to connect to, 2 at the top & 2 at the bottom. Do I need to do something different w/ the power supply since it's already connected to the track?
I want to use the steering wheel controller to set the pace on the track and take another car w/ a hand held controller to race against myself.

Thanks,
fordcowboy
Missouri

hey FCB!

Check this link.

http://www.modelmotorist.com/web-content/tj2wb.jsp

I did this same thing a long time ago, (pre wood track) and will do so again with hidden steering wheels.
You must wire the top of your controller to your track and the botton of your controller to your power. You will probably have to fiddle with rail choice with the top wires, but I am sure you will get it.
Good luck!

Thanks alot Joe. I will try that. good wed site.